Test Tube bud vase

Click HERE for the file!

Cutting File

Upload your file and line it up on your chosen material.  There is a tiny T on the top and a tiny B for the bottom pegs to make assembly easier.  This step is optional.Once you are ready hit the button and watch the magic happen!

You can use any material but please note that you may need to adjust the slots so they will fit properly.  

Assembly

Lay out all 4 pieces.  If you engraved the T and B's then this step will be easier.

I started with the bottom and places both pegs into the base.  The base is the one with the smaller hole.

Next I flipped it over and placed the top pegs in the the top piece.

Last assembly step is to slide the test tube into place.  

Materials Used

(Disclosure: Some of the links below are affiliate links, meaning, at no additional cost to you, I will earn a commission if you click through and make a purchase.)

If you don't already have a glowforge what are you waiting for!  Click on the picture to a discount of up to $500 on your purchase!

Any 1/8 inch material will work.  I used frosted acrylic and wood.

This is the link to the test tubes I used.  Just click on the photo!